I'm sure this has been addressed previously, but wanted to know if anyone could help me out quickly....I'm working on a project for a gasoline/fuel oil terminal, where fuel is delivered to tanks via a

I forgot to say that I fitted this to a truckmount carpet cleaner a few years agoIt was a 16bhp briggs and stration carboretor with an inline fuel filterI did the job of getting fuel from the tank und

Not sufficient information to make any qualified comments.You need to supply inlet and outlet conditions, pipe work configuration, relative levels of source and discharge point, pump curve etc flow ra

Hi There,Have anybody experienced reverse flow in a running pump? I have been told by plant operator that once he finished unloading first compartment and remove the empty suction hose to next compart

I was hoping to get some confirmation on some minor pressure loss calculations I am doing, seeing as how I am getting wildly different values depending on whether I try to use the minor loss coefficie

I have a split case pump on a cooling tower. That is vibrating and noisy. While checking this pump out after a total rebuild I noticed that I have a negative suction on this pump. If I open the value

An answer to within 10% for a calculation like this would be as precise as you could ever get. A reasonable estimate would be

Yes, a pump manufacturer or reseller would or should consider the full load motor speed in calculating impeller trim and so should you as the end user if you are selecting the motor based on the pump