i'm using a centrifugal pump to pump RO water. The RO water originally has some fine air bubbles. But they should leave over time.I have a flooded suction with a 2.5" suction, and about 1ft of strai

Does anyone know a good source on the web for accurate equivalent lengths of pipe fittings. I have searched & located several sites, but they all seem to vary significantly & especially compared to sa

why do we find two different sets of pump affinity laws in literature and on the web:One set is correct (according to my knowledge) and says that for constant shaft speed the following is true Q1/Q2=D

600KW equals 805 HP if I did the math right and at 5,000 PSI that would require 276 GPM of flow which would produce over 34,132 BTU/Min. of heat. At lower pressure flow would increase but heat would r

If you imagine a single plunger of the pump to move approximately in accordance with a sinus, the plunger head location could be represented as x(time) = Half_stroke x sin (rotational_speed x time).

I'm sure this has been addressed previously, but wanted to know if anyone could help me out quickly....I'm working on a project for a gasoline/fuel oil terminal, where fuel is delivered to tanks via a

Free Pump Trials Demonstrate Peristaltic Benefits

About Performance Measures of Vacuum Pump